Issue:
Test serial PTZ control
Environment:
- Rise series
- WinMPC_V4918.EXE
Procedure:
- Locate your RS-422 wire from the Prepped accessory cable.
- Wire pins RS-422 from the camera to the converter.
- Open WINMPC Software
- Click on Camera setup
- Confirm Comm Port, Baud Rate matches to *computer PC setting
- Select Receiver type "4200" for Rise series
- Set Cam Comm Protocol "Cohu" Press ok
- Set address
- Click on the arrow to move PTZ
*Note: PC | Device Manager>Ports(Com& LPT)
WINMPC click on the link WinMPC_V4918.EXE to download :
Comments
0 comments
Article is closed for comments.