RISE: How to test MIB's

Issue:

The customer reports there is an issue with RISE cameras and MIBS.

Environment:

RISE 1, 2, 3
Free mib tool: https://www.manageengine.com/products/mibbrowser-free-tool/
MIBS are attached at the end of this article.

Resolution:

1. Enable SNMP on the camera.
   • RISE 1 - From the webpage click Network > SNMP Settings > SNMP Mode > Set it to v1/v2c and make note of the Community name > Click Save.
   • RISE 2 and 3 - From the webpage click Protocol > SNMP Settings > SNMP Mode > Set it to v1/v2c and make note of the Community name > Click Save.
2. Download and install the MIB tool listed above.
3. Launch the tool ManageEngineMIBBrowser.
4. If this error comes up just click OK.
   
   
   
   
5. Click File > Load MIB.
6. Point to the MIB attached to this article and click Open.
7. Run SNMPWALK using the below steps.
   1. Type the IP address of the camera in the Host field.
   2. Type in the community name that the camera is using. In our example it's "public".
   3. On the left click the + icons until you get to cameraObjects. Right-click and select SNMPWALK. This will run everything within that folder.
      
      
      
      
8. You will see the output listed below.